1 / 5

Stave loading with Si-heaters at UniGe with jigs v-1

Stave loading with Si-heaters at UniGe with jigs v-1. Maarten, Coralie , Franck, Didier. August 2011 . Work Preparation for the Loading Activities - Jigs. Handling frame inside the cradle. Grease mask added. Grease mask added. Half stave loaded. 2 nd added with 200µm gap.

cady
Download Presentation

Stave loading with Si-heaters at UniGe with jigs v-1

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Stave loading with Si-heaters at UniGe with jigs v-1 Maarten, Coralie, Franck, Didier August 2011

  2. Work Preparation for the Loading Activities - Jigs Handling frame inside the cradle Grease mask added Grease mask added Half stave loaded 2nd added with 200µm gap 1st Si-heater or digital module Wing handling to free the loading space Wing glue + adhesive hold in an envelope defined by the jig 2

  3. Loading with Si-heaters - Pictures

  4. Few comments about jigs v-1 • The adjustable feet (4 micrometric screws) are there to allow an average co-planarity between cradle blocks and the face plate. Warning: It can easily induce stress to stave! • 1st Si-heater will have to be glued with fast Araldite to give reference for the neighboring modules • Loading cradle is only compatible for Al-handling frame • It allows to load heaters and digital modules • The wing retract mechanism does not exist yet and need to be made for stave-1 • The wing gluing has also to be investigated – To be worked out

  5. Cabling Equipment for Thermal Tests • Two Ag-silicon junction done thanks to electrical conductive glue and Cu-strips • 1.5 mm2 wire section used to allow powering individual modules • Thin cables and split in 4 wires for the PT100 readout • NB: • -The stiffness of the services was found not very compatible with the weakness and fragility of the loaded modules • - A Stress relief bar was designed and machined (thanks to Maarten & Gaby) to maintain all the cables above (49 in total leaving the stave) • - The handling frame v-1 (5x5 cm2 of CFRP) was made to hold the stave and Al-plate extenders were added for the pipe stress relieve • - An asymmetric cover was designed to protect the stave Warning: This cabling is not compatible for the thermal mock-up!

More Related