1 / 15

UAV Radar Project Preliminary Design Review T eam B

UAV Radar Project Preliminary Design Review T eam B. Team Lead Kelly Rodriguez Design Lead Brittany Limones Construction Lead Kenneth McChesney Test Lead Ned Howard. Level 0 Block Diagram. Level 1 Block Diagram. Level 2 Block Diagram. Transmitter. Receiver. Test Procedure.

callie
Download Presentation

UAV Radar Project Preliminary Design Review T eam B

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. UAV Radar ProjectPreliminary Design ReviewTeam B • Team Lead Kelly Rodriguez • Design Lead Brittany Limones • Construction Lead Kenneth McChesney • Test Lead Ned Howard

  2. Level 0 Block Diagram

  3. Level 1 Block Diagram

  4. Level 2 Block Diagram

  5. Transmitter

  6. Receiver

  7. Test Procedure • Phase I: Component Confirmation • Phase II: Interface Evaluation Boards • Phase III: Final Transceiver Testing

  8. Phase I • Phase I: Component Confirmation • Order/Create Evaluation Boards to validate each component • 20 mil trace thickness on Rodgers board material • Create boards in Eagle and send out for manufacturing • Individually test each component to ensure anticipated operation • Measure S21 to find and confirm intrinsic loss and operating range • Measure S11 to confirm impedance matching(~-20dB) over operating range • Determine the amount of current drawn given operating voltage

  9. Example of S-parameter comparisonBand Pass Filter: SAW B9496 S-21 from Network Analyzer S-21 from datasheet

  10. Phase II • Phase II: Interface Evaluation Boards • Connect test boards together using SMA cables and test system for: • power levels (stay away from saturation). • noise (make sure SNR requirements are met). • Replicate one receiver chain then apply LO signal for mixing and echo reply at receiver port • Connect various components and confirm power loss and impedance matching.

  11. Phase III • Phase III: Final Transceiver Testing • Confirm correct footprints, vias, and soldering • High speed oscilloscope available for probing high frequency circuit • Test board by connecting the transmitter port to the receiver port with a fiber optic delay line • 2.4 GHz input and MHz output depending on length of delay line • Interface board with waveform generator • Interface board with entire system and cross fingers….

  12. Risk Mitigation

  13. WBS

  14. Project Schedule

  15. Any Questions?

More Related