1 / 12

D isplacement of BRT

D isplacement of BRT. Junko Katayama. Transmission Monitor System. TMS. ETM. BRT. GPT. QPD. What I did. Lateral and angular motion of BRT cause the noise on QPDs. I computed those BRT motion noise and shot noise for both SOFT and HARD mode in two cases ; TMS table fixed on the ground

dugan
Download Presentation

D isplacement of BRT

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Displacement of BRT Junko Katayama

  2. Transmission Monitor System TMS ETM BRT GPT QPD

  3. What I did Lateral and angular motion of BRT cause the noise on QPDs. I computed those BRT motion noise and shot noise for both SOFT and HARD mode in two cases ; • TMS table fixed on the ground • TMS suspended by pendulum

  4. Angular motion There are two types of angular motion. • Surface wave on the ground (v=5000m/s) Θ = 2πf * xseis / v • Table motion (simulation data from ATC) y1 Z-rotation X,Y-rotation x1 s1 = x1 s2 = -1/2*x2 + √3/2*y2 s3 = -1/2*x3 - √3/2*y3 Rθz =(s1+s2+s3)/3 z1 y3 y2 z3 z2 x3 x2 Rθxy = (((z2+z3)/2)*2-z1)

  5. Angular motioncomparing surface wave & table move ↑ dominant

  6. Table motion is quite smaller than surface wave → consider only surface wave as the angular motion of BRT From the next slide, I computed the noise contribution to h for each SOFT and HARD mode. There are two lines with each noise ; Ex) shot1 : shot noise on QPD1 shot2 : shot noise on QPD2

  7. SOFT modefixed on the ground

  8. HARDmodefixed on the ground

  9. Transfer Function z1 z2 d=1m , M=200kg d X = 1/(1-(ω/ω0)2+iω/Qω0)*xseis Θ = dk(1％*xseis)/(-Iw2+2d2k) z2-z1=1％*xseis I=M(2d)2/12 Mg ↑ Suspended by 2 wires

  10. SOFT modesuspended

  11. HARD modesuspended

  12. Conclusion • rotation of TMS table is not dominant → surface wave is dominant • we can get HARD signal with TMS suspended …cannot get SOFT because of the shot noise

More Related