1 / 25

Some Aspects of Energy Efficiency and Energy Conservation in Power Generation Industry

ITC. Krzysztof Badyda INSTITUTE OF HEAT ENGINEERING WARSAW UNIVERSITY OF TECHNOLOGY. http://www.itc.pw.edu.pl. Some Aspects of Energy Efficiency and Energy Conservation in Power Generation Industry (Round Table discussion).

neorah
Download Presentation

Some Aspects of Energy Efficiency and Energy Conservation in Power Generation Industry

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. ITC Krzysztof Badyda INSTITUTE OF HEAT ENGINEERING WARSAW UNIVERSITY OF TECHNOLOGY http://www.itc.pw.edu.pl Some Aspects of Energy Efficiency and Energy Conservation in Power Generation Industry (Round Table discussion) Conference on the Future of Energy in Enlarged Europe: Perspectives for R&D Co-operation A contribution within the context of the Weimar Triangle October 7- 8th, 2004, Warsaw

  2. ITC General information The Warsaw University of Technology (WUT) is the largest academic school of technology in Poland, employing 2.000 professors. The number of students is 30.000, most of them study full-time. There are 17 faculties covering almost all fields of science and technology. The Institute of Heat Engineering is part of the Faculty of Power and Aeronautical Engineering (FPAE - MEiL) of the WUT. Staff of the Institute - 130 persons, incl. 30 doctor students, and 25 technical and administration staff.

  3. ITC Institute of Heat Engineering: structure Management:Prof. Janusz Lewandowski Prof. Jerzy Banaszek - didactics and research Dr Tomasz Wiśniewski - technical aspects, organisation and finance Division of Refrigeration, Machines and Equipment for Chemical and Food Industry -Prof. Jerzy Sado Division of Power Engineering -Prof. Andrzej Miller Division of Thermodynamics -Prof. Roman Domański Division of Aircraft Engines -Prof. Piotr Wolański Division of Pumps, Drivers and Power Stations -Prof. Waldemar Jędral

  4. ITC Division of Power Engineering: specialities Scientific fundamentals of machine design and operation. Apparatus and their sets in power engineering. Development of methods for mathematical modelling and simulation of performance under design, off-design and transient conditions. • Objects • Utility and captive power plants • Steam and gas turbines • Combined and cogeneration sets • Digital simulators of power plant equipment – turbosets, boilers • New applications of distributed control systems • Clean coal and environment protection technologies • Hydrogen and fuel cells

  5. ITC Division of Power Engineering: partners/customers • Transition Technologies (TT) – a company specialised in implementation of new computer technologies in power plant engineering • Alstom Power Poland – steam and gas turbine manufacturer • Vattenfall – owner of the largest combined heat and power plant in Europe (Siekierki – 620 MWel and 2000 MWth) • BOT Group – owner of the largest power plant in Poland (capacity of 12370 MWel) • PKN ORLEN – owner of the largest oil refining and petrochemical plant in Poland, and of the largest captive CHP plant in Poland • Power plants and combined heat and power plants (utility and captive, including the distributed power sector)

  6. ITC Division of Power Engineering: international partners/co-operation • National Institute of Advanced Industrial Science and Technology, Tsukuba, Japan • San Diego State University, California, USA • Kharkov University of Technology, Ukraine • Moscow Power Engineering Institute (MEI), Russia • University of Western Australia, Perth, Australia • International Industrial Assessment Center DOE,Philadelphia USA (energy audits in industry)

  7. Division of Power Engineering: Typical projects in the area of energy saving (realised in co-operation with industry) ITC • Modernisation of turbines: adapting of flow systems to off-design operating conditions • Modernisation of boilers: adapting to off-design operating conditions and/or increase of efficiency • Energy audits for power and other industrial plants, proposals of production process modernisation or modification • Modelling of energy and technology systems, process losses determination • Optimisation of load distribution in combined heat and power plants using automatic model construction (DCS) • New applications of distributed control systems in power generation industry

  8. ITC Energy audit at Siekierki Combined Heat and Power Plant Sankey diagram of energy flows for part of the Siekierki CHP plant in typical conditions

  9. ITC Boiler driving with neural networksin Połaniec Power Plant Primary steam Combustion temperature Temperatures and their differences Secondary steam PW1...6 Concentration L,RCO O2 NOx OFA WM1...6 MW1...6 Secondary air Outlet gases temperature L,R Total air

  10. ITC Optimisation results • Reduction of NOx emission by approx. 15-25% • Efficiency increased by approx. 0.2 - 0.7% • Elimination of CO • Number of flammable parts not increased • Economic operation of actuators • Safe switching over (supervision system) • Improved system reliability

  11. gas gas gas gas gas gas gas oil oil oil oil oil oil oil B1 B4 B2 B3 B5 B7 B6 12.8 MPa TG1 TG2 TG3 TG4 TG5      3.4 MPa 1.8 MPa 0.75 MPa 0.12 MPa ITC Optimisation of load distribution at a CHP plant Simplified heat diagram

  12. ITC Optimisation results Nel [MW] t [h] t [h] Generated electric power Relative obtainable fuel savings

  13. h = 84,5% c h = 66,4% R h = 66,4% HHV h = 77,2% LHV ITC Hydrogen Turbine ProjectWE-NET – co-operation with Japan Modified New Rankine Cycle (MNRC) proposal of ITC O2 H2 O2 H2 O2 H2 HPT MPT LPT

  14. ITC Pressurised fluidised bed boiler installation diagram

  15. ITC Power generation industry in Poland Installed capacity: 35000 MW. Electricity generation of distributed power generation sector: very low – installed capacity (end of 2002 – excl. industrial power): wind power 31 MW, biogas 42 MW, small water plants 492 MW. Contribution to the energy production: 0.2%. Needed intensive development of electricity sources using renewable energy. Relatively high rate of electricity production combined with heat generation. Combined heat and power plant capacity: domination of large plants. Domination of coal in the energy sector.

  16. ITC Cogeneration electricity production rate in Poland from 1985 to 2002 Average for EC („old” 15) in 2000: about 10%.

  17. ITC Rate of combined electricity production 2001 (selected „old” and „new” EC members)

  18. ITC Domination of coal in the electricity production in Poland Hard coal and lignite: 93% !!

  19. ITC Energy efficiency and energy savings: proposals of co-operation • Research on advanced power systems with use of hydrogen, esp. two-source systems • Research and analysis of clean coal technologies • Analysis of new concepts of zero CO2 emission power generation technologies • Fuel cell hybrid systems - research and development • Implementation of mathematical modelling of power installations in collaboration with distributed control systems (DCS) • New concept of power plant information system

  20. ITC Fuel cell hybrid systems Recently, the interest in investigation on ultra-efficientelectricity generation systems is focused on the application of fuel cells. From distributed generationpoint of view(200 kW to 20 MW), two types of fuelcells are considered: Molten Carbonate Fuel Cell and Solid Oxide Fuel Cell.These types of fuel cells require more complex configuration of power plant cyclefor proper operation. The introduction of fuel cell into power plant cycle creates a hybrid system. The research and development of these hybrid systemsis a key for future use ofthis kind of energy sources. The focus of investigations should be laid ondesign, off-design and dynamic simulations of hybrid systems.

  21. Implementation of mathematical modelling of power installations in collaboration with distributed control systems (DCS) ITC The new abilities for data transfer and recording within the DCS make the implementation of different application software possible. The software co-operating with DCS can also generate information for the system. That makes simulation of operation of controlled installation elements possible. Examples of projects of implementation of mathematical modelling for DCS applications, realised in our Institute: digital simulator of a back-pressure extracting steam turbine, digital simulator of a steam boiler, optimisation of load distribution in captive and utility power plants (combined heat and power), software products supporting operation of power plants .

  22. ITC New concept of power plant information system Distributed control systems (DCS) are installed in all major power and industrial plants. The automatic collection of technical data and computer processing ability open and even force new opportunitiesof process control and maintenance. On the other hand, a new concept of management information system (MIS) organisation in power plants and companies should be done. The new policy on the Polish energy market strongly speeds the consolidation of generators into power concerns up. Therefore, in several enterprises kind of remote management centres will be created. New MISs need to be used for them. A concept of complex utilisation data warehouse and “power portal” (internet type GUI), which seems to be the most suitable for this kind of application, was presented in multiple papers.

  23. ITC Krzysztof Badyda INSTITUTE OF HEAT ENGINEERING WARSAW UNIVERSITY OF TECHNOLOGY http://www.itc.pw.edu.pl • THANK YOU • FOR YOUR KIND ATTENTION ! Krzysztof Badyda D.Sc., Ph.D.ProfessorWarsaw University of TechnologyInstitute of Heat EngineeringNowowiejska 25 Str.pl 00-665 Warszawatel. (+48-22) 660-5281, 825-29-01fax. (+48-22) 825-25-65e-mail: badyda@itc.pw.edu.pl Conference on the Future of Energy in Enlarged Europe: Perspectives for R&D Co-operation A contribution within the context of the Weimar Triangle October 7- 8th, 2004, Warsaw

More Related