1 / 10

Toroid Control System

Toroid Control System. Sheng Peng 02/08/2006. Outline. Requirement External Interface Schedule Design Maturity Wiring Budget. Requirement. There are four mechanical types of toroid Three of them are the same to control Toroid type 1 is in the GTL region

sherip
Download Presentation

Toroid Control System

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Toroid Control System Sheng Peng 02/08/2006

  2. Outline • Requirement • External Interface • Schedule • Design Maturity • Wiring • Budget

  3. Requirement • There are four mechanical types of toroid • Three of them are the same to control • Toroid type 1 is in the GTL region • Toroid type 2 is in the region downbeam from L0 • Dump toroid • BCS toroid will be different, TBD • Fourteen toroids in total except BCS • Four toroids in injection line • Preamplifier is needed downstairs • Control system will interface with preamplifier to read signal, and give test signal to toroid

  4. Requirement • Charge and Frequency Range: 2-1200pC • single pulse measurement at a frequency range of 1 Hz < f < 120 Hz • Resolution: 2 pC • Readout: 0 - 10Volts • Low Range Charge Accuracy: 2% RMS (linear) • High Range Charge Accuracy: 2.5% RMS (linear)

  5. 8Turns Pre-Amp ADC/ QADC Timing 1 Turn Trigger2 DAC Trigger1 Cycle start Send test signal Beam charge? Measure test signal Trigger1 Trigger2 External Interface

  6. Control Interface At lease two signals come from pre-amp • Generate calibration charge • Read back calibration signal to calculate gain • Scan timing window to find the right delay • Read beam charge signal within right timing window

  7. Schedule • Date needed: Dec, 2006 • Determine the QADC/ADC in Feb 2006 • Control’s prototype ready in ~July, 2006 • Hardware order date: TBD • Hardware delivery date: TBD • Installation: July ~ September, 2006 • Test period: one ~ two months • Toroid commissioning will be in Dec, 2006

  8. Design Maturity • Toroid ESD 1.3-107(10/2005) is currently in use • The mechanical engineer is working on two proposal bids • The detailed interface will be defined after the winner is selected • Bergoz comes with preamplifier but ISA doesn’t, so SLAC might design the preamplifier if ISA wins

  9. Wiring • Timing system is needed • Test input connector will be type N • Signal output connector will be TWINAX (or SMA as Bergoz proposed) • Wiring will be bakeable, radiation hard and qualify cable loss requirement • Cable is already planed for injection line, cable type is TBD • For injection line, one IOC may be enough • Control interface and software will be dependent on the selection of preamplifier

  10. Budget • ~ $10,000/toroid • Control budget: • Estimate depends on design of preamplifier

More Related