1 / 5

VCC Hardware Production Status

VCC Hardware Production Status. Production VCC Locations and Dispositions. Firmware compile issues delayed testing and burn-in. Last 15 boards passed pre-burn-in testing Post burn-in testing in progress. . VME Crate Controller Issues.

mandell
Download Presentation

VCC Hardware Production Status

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. VCC Hardware Production Status Production VCC Locations and Dispositions • Firmware compile issues delayed testing and burn-in. • Last 15 boards passed pre-burn-in testing • Post burn-in testing in progress.

  2. VME Crate Controller Issues • User reported firmware issues are resolved by combination of: • Replacing 1.5V power inductor with short (Vcore tolerance issue). • Installing service pack 2 and recompiling with ISE 8.202i. • Saving correct user configuration settings for power up in Flash mem. • Resolving driver conflicts with multiple NICs. • However new issues have come up in new compiles (with no logic changes) • DCM’s failing to lock or loosing lock before power-on startup finishes. • Internal FPGA timing issues with a few (not all) boards even though the compile passed all timing constraints (like missing data or double data on some VME reads).

  3. VCC: Addressing the Issues • DCM issues have been addressed by reconfiguring the clocks and modifying the startup procedure. • Timing issues have been addressed by slowing down the clock. • Main clock is 16ns. • VME interface front-end clock is 4ns. • Changed the 4ns clock to 8ns. • Changing the clock affects VME timing parameters • Implementation of VME rules was based on a 4ns clock. • Rules that are based on minimum times will be OK (just lengthed response times). • Other rules (such as “release within …”) potentially could be violated with the 8ns clock. • The exact implementation details need to be checked and/or adjusted.

  4. VCC: Latest Revision • Revision 3.69: • Uses 8ns VME interface clock. • More robust DCM monitoring and startup. • Known problems in previous revision are not present in 3.69. • Available for downloading on the controller web page • http://www.physics.ohio-state.edu/~cms/GbE_Ctrl • Not extensively tested yet, but very promising.

  5. VCC: Outlook • Hardware Modifications Needed. • Replace inductor for 1.5V regulator with short. • Add 10 uF Tant. bypass caps for oscillators (these were omitted during original board assembly). • Firmware Development Work. • Investigate consequences of 8ns clock on VME rules. • Adapt the implementation to 8ns clock. • Test and verify proper timing. • Distribute a reliable firmware revision. • Proceed with firmware development. • Packet acknowledgements. • Ethernet firmware downloading.

More Related