1 / 7

MUON piquet report 24/4 -30/5 2012

MUON piquet report 24/4 -30/5 2012. Nikolai Bondar. Technical Stop 23/04-27/04. Access till 26/04. 28/04 – 30/04 LHC team working with machine.

hal
Download Presentation

MUON piquet report 24/4 -30/5 2012

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. MUON piquet report 24/4 -30/5 2012 Nikolai Bondar

  2. Technical Stop 23/04-27/04. Access till 26/04. 28/04 – 30/04 LHC team working with machine. The first collisions since the technical stop were taken this morning, with LHCb collisions dedicated to take time-alignment events for the muon system, to allow studies of the efficacy of the aluminum chamber covers. Physics fills should happen later today.

  3. Works done this TS: Condition chambers on A-side Recovered – M2R4: (10,12,14,16)D gapB M4R3 10A gapD M5R3 21A gapD M5R4: 03(A – D) gapD; 04(A-D) gapC; (10,12,14,16)D gapB; (18,20,22,24)D gapD Improved , but not completely recovered – M3R3 18B gapC M5R3 12A gapA; 22A gapB; 24A gapB M5R4 08(A-D) gapC; (10,12,14,16)D gapC; 30(A-D) gapC Chambers on C-side were not conditioned because of lack of time

  4. Electronics • Q2M1R1 _3/191 Sync 23 – little hole on ODE-level, see details in [[https://lblogbook.cern.ch/MUON/3156][https: //lblogbook.cern.ch/MUON/3156]] SYNCs 0-5 swapped with 18-23 (triple SYNCs). Connectivity test Ok. The hole disappeared 2. Check SB-side no counts rate seen from internal counters , see details in [[https://lblogbook.cern.ch/MUON/3087][https://lblogbook.cern.ch/MUON/3087]] • A M1R1-16A2 SB1/8-11 - FEBs 18-23 Pin #2(black wire) of control cable shorted to ground on chamber side. • A M3 R2-17A3 SB14/3-5 Corresponding ELMB replaced • C M2 R2-19A1 SB2/6-8 (as a spare I used the spare ELMB • C M3 R2-13A3 SB3/3-5 from the same board or adjacent board)

  5. 3. Installation of ferrite cable filters to reduce the noise, see details in [[https://lblogbook.cern.ch/MUON/3153][https://lblogbook.cern.ch/MUON/3153]] On the control cable of chambers AM1R2-15A3; CM1R2-15A3; CM1R4-19; CM5R4-29B - ferrite rings were installed. Effect is not very good On the control cable of chamber CM4R4-30D – ferrite ring does not help. The problem needs more investigations

  6. Test shielding back side of M5 Aluminum shield (thickness ~ 5mm) installed on A side at the of M5 M5 M5R2 M5R3 M5R4 M5R1 Detailed information will be presented by Rolf

  7. HV trips See logbook: 3215  30-Apr-2012 09:22MUHVA02:MUONInfoTripped ChannelM1A05A_GAPB - tripped - excluded.  3214  29-Apr-2012 08:51MUHVC02:MUONInfoTripped ChannelM1C24A_GAPA - tripped - excluded. - included 3213  28-Apr-2012 01:34MUHVA02:MUONInfoTripped ChannelM1A09B_GAPB - tripped - excluded. - included

More Related